How To Install Relay For Fog Lights

It is for this reason that we present here the proper way to wire a fog light systems. Engage the parking brake.

Replacing a fog light relay.

You can find out more Diagram below

How to install relay for fog lights. Install a piece of 10 gauge wire with a yellow butt connector to the black ground wire at the fog light and attach it to a good ground on the frame with the yellow oval connectors. Pick the right fog light. Locate the underhood fuserelay box.

One of these wires from each fog light has already been connected to ground. Install the fog lights in the desired location with the provisions in the kit. Determine where you are going to mount or install the fog light on your car.

Without this current no magnetic force is created so the 30 to 87 switch stays open. Install your fog lights. Part 1 of 1.

By default this switch is open so current cannot get from the battery to your lights. The fog lights each have two wires one for ground and one for the 12v power. It connects to the positive side of your battery or to a switched power source that only gets power when your ignition is on.

Manufacturers will typically label the box with the. Layout the wiring for your fog light. Finally attach the switch to the dash and the relay to its location.

General installation guide for wiring relay harness with on off switch this is a general installation guide on how to wire a relay harness and switch kit. You might want to decide whether to get a yellow colored fog. Bumper mounted fog lights are typically below the headlights.

How to wire aux lights fog lights led lights light bar or anything else to a switched circuit in your vehicle the right way. Try to have it on as level a surface as possible. The lid of the fuserelay box can usually be removed by.

Check your vehicle manual if you have difficulty locating them. How to install fog lights. How to wire your led light bar using a relay.

The etiquette rules for fog lights are the same as for bright high beams. Remove the underhood fuserelay box cover. Always choose a fog light that is appropriate for your car.

Open the hood and locate the fuserelay box. These instructions apply to any car but for the sake of this guide we will be using the ford f 250 as a reference car to wire an led light bar. Make sure your vehicle is parked and turned off.

A test is in order before you use the lock ties and button everything up.